Made to Order
Tube Size | Dia. 6 mm., 6.5 mm., 8 mm., 8.5 mm., 11 mm., 11.5 mm. |
Type of Tube | Copper, SUS304, SUS316, INCOLOY |
Voltage (Volt) | 110V, 220V, 380V |
Watts (Watt) | as appropriate of size of heater |
Characteristics
Immersion Heater is designed to easily install in boiling tank which has screw or has no screw, but a female screw can be applied as outside seal.
Terms of Use
– Select the tube of heater as appropriate to usage.
– Do not overload and do not increase temperature higher than the company’s suggestions
– Be ware of liquid or water level to go below hot zone of heater, causing a shock circuit.
– Frequently clean the dregs on heater surface every 3 months.
– Immersion Heater should always be installed at bottom level of tank, and should have thermostat attached to heater.
– A Float level switch is suggested to give signal of new supply of water or liquids, in order to protect heater from burning itself.